<%@ CODEPAGE=65001 %> <%Response.Charset="UTF-8"%> Promethazine Hydrochloride Syrup
Promethazine Hydrochloride Syrup
(Current title—not to change until June 1, 2005)
Monograph title change—to become official June 1, 2005
See Promethazine Oral Solution
» Promethazine Hydrochloride Syrup contains not less than 90.0 percent and not more than 110.0 percent of the labeled amount of C17H20N2S·HCl.
Packaging and storage— Preserve in tight, light-resistant containers.
USP Reference standards á11ñ USP Promethazine Hydrochloride RS.
NOTE—Throughout the following procedures, protect test or assay specimens, the Reference Standard, and solutions containing them, by conducting the procedures without delay, under subdued light, or using low-actinic glassware.
Identification— Treat 25 mL of Syrup as directed in the Assay, ending with “using a current of air only.” Dissolve the residue in 2.5 mL of carbon disulfide, filter through paper if necessary, and determine the IR absorption spectrum as directed under Identification—Organic Nitrogenous Bases á181ñ, obtaining the spectrum of USP Promethazine Hydrochloride RS as directed: the Syrup meets the requirements of the test.
Assay— [NOTE—Use low-actinic glassware in this assay.] Transfer an accurately measured volume of Syrup, equivalent to about 25 mg of promethazine hydrochloride, to a 250-mL separator. Add 10 mL of ammonium hydroxide, and extract the promethazine base with six 40-mL portions of chloroform. Wash the combined chloroform extracts with 25 mL of dilute hydrochloric acid (1 in 9). Wash the acid solution with 25 mL of chloroform, and add the washings to the main chloroform extract. Evaporate the chloroform extract on a steam bath, with the aid of a current of air, to a volume of 5 to 10 mL, and finally evaporate, using only a current of air, to dryness. Dissolve the residue, with slight warming, in dilute sulfuric acid (1 in 100), and transfer to a 500-mL volumetric flask with the aid of additional acid. Cool, add dilute sulfuric acid (1 in 100) to volume, mix, and filter, rejecting the first half of the filtrate. Dissolve an accurately weighed quantity of USP Promethazine Hydrochloride RS in dilute sulfuric acid (1 in 100), and dilute quantitatively and stepwise with the dilute acid to obtain a Standard solution having a known concentration of about 50 µg per mL. Concomitantly determine the absorbances of both solutions in 1-cm cells at the wavelength of maximum absorbance at about 298 nm, with a suitable spectrophotometer, using dilute sulfuric acid (1 in 100) as the blank. Calculate the quantity, in mg, of C17H20N2S·HCl in each mL of the Syrup taken by the formula:
500(C / V)(AU / AS),
in which C is the concentration, in mg per mL, of USP Promethazine Hydrochloride RS in the Standard solution; V is the volume, in mL, of Syrup taken; and AU and AS are the absorbances of the solution from the Syrup and the Standard solution, respectively.
Auxiliary Information— Staff Liaison : Karen A Russo, Ph.D., Scientist
Expert Committee : (PA1) Pharmaceutical Analysis 1
USP28–NF23 Page 1643
Pharmacopeial Forum : Volume No. 28(2) Page 349
Phone Number : 1-301-816-8379